Sistema de Informação Federal
Code Page utf-8
Sistema federativo informativo sobre produtos e serviços
FISinter

Подсистема «Информация производителей продукции»

Escolha da língua
Busca da informação
Colocação da informação
Porminores
Настройки браузера
Архив

Materias de construção, casas e construções

Estuque decorativo "ANKER"

 
País: Rússia
 
 Tipo de fornecedor: Produtor  
 Informação sobre fornecedor  Identificadores de produçäo

Explicação, anotação:

High-quality mineral mortar for plastering. Frostproof. water resistive. Ecologically clean. High adhesion.

Descrição porminorizada da marca:

Application: at all mineral grounds, such as the concrete, cement, öåìåíòíî-èçâåñòêîâûå inside and out building is deposited. Is applicable to manufacture of high-quality çàòèðî÷íîé plaster in the system complex heat insulation. property: the mineral mortar for plastering is fabricated on the basis of carefully selected filling agent, öåìåíòíî-èçâåñòêîâûõ astringent and special polymer additives, the allotment of that provides good the cohesion with ground, the vapour permeability, the adaptability to manufacture processing, the increasing the efficiency of expenditure, high soil moisture retention capacity. surface preparation: the surface should be dry, dust-free and dirt , butters and other pollutions of organically derived. preparing of mortar for plastering: the mortar for plastering ïðèãîòàâëèâàåòñÿ way of careful mixing with water by hand or mechanically, in ratio of 0, 21-0, 25 waters l by 1 kg dry mixture to receipt required consistency. In operation should be used all content sack. fulfilment of high-quality plaster: the mortar for plastering are deposited on the basis after drying preparatory layer with the help of glabrous metal grater. the surface it levels off to grain depth, and then çàòèðàåòñÿ glabrous plastic grater to needed invoice. Time between coating the plasters and the rubbings depends on absorbing capacity of ground and consistency. One should experimentally to establish maximal the surface, which it is possible îøòóêàòóðèòü in one processing cycle (the coating and the rubbing). expenditure: the expenditure of dry material amount to about 3 kg by 1 ì2 in case of depth deposited layer 2 MM. technical data: mixture proportion: by 1 kg - 0, 21-0, 25 waters l; by 1 sack (25 kg) - 5, 25-6, 25 waters l; application temperature - from +5 degree. With; fitness time of solution - 2-3 part. the product was admitted to use the solar power station,. Moscow.

Condições de fornecimento:

Preço combinado por kg