Explicação, anotação:In the manufacture of polymer capacities by the blow method. Primary raw material polyethylene, polypropylene.
Descrição porminorizada da marca:Main nodes of design:
- device of heating and preparing of product ;
- automated manipulator for blank transfer in the zone of blow;
- closure mechanism of press moulds;
- automatic manipulator of products doffing;
- the control box.
the constructive drawing up - the monoblock unit and the individual control box.
the automatic machine is equipped with the pneumatic equipment, controller of rotary of extruder auger key companies of manufacturer.
the completing by extrusion heads:
- dual-stream for products from 0, 75 to 1, 0 litres - base enters the delivery set;
- òðåõðó÷üåâàÿ for products from 0, 3 to 0, 75 litres - ñïåöçàêàç is outside the delivery set;
- ÷åòûðåõðó÷üåâàÿ for products from 0, 05 to 0, 3 litres - ñïåöçàêàç is outside the delivery set.
the technical characteristics:
1. Capacity (for three of brook), øò/÷àñ. 660;
2. Working pressure, MPa. 0, 4-0, 6;
3. Air consumption, ì^3/ìèí to. 0, 5;
4. Water expenditure to, ì^3/÷àñ. 1, 5;
5. Supply voltage of three-phase network, V.. 380;
6. Water temperature, degree. S. 10-12;
7. Installed capacity, kilowatt. 13;
8. Power consumption, kilowatt. 10;
9. Overall dimensions:
length, MM. 2620;
width, MM. 2365;
height, MM. 2250;
10. Mass, not more. 1850. |
