FISinter (to initial point)
Code Page utf-8
Das föderative Informationssystem über Güter und Dienstleistungen
FISinter

Подсистема «Информация производителей продукции»

Wälen Sie die Sparche
Die Suche der Information
Die Unterbringung der Information
Einzelheiten
Настройки браузера
Архив

Baubedarf und -Konstruktionen, Häser, Anlagen

Dekorativputz _________ "ANKER"

 
Das Land: Russia
 
 Der Lieferantentyp: Warenhersteller  
 Die Information über den Lieferanten  ProduktionsIdentifizierer

Die Erklärung/Inhaltsangabe:

High-quality mineral mortar for plastering. Frostproof. water resistive. Ecologically clean. High adhesion.

Die ausführliche Beschreibung der Marke:

Application: at all mineral grounds, such as the concrete, cement, öåìåíòíî-èçâåñòêîâûå inside and out building is deposited. Is applicable to manufacture of high-quality çàòèðî÷íîé plaster in the system complex heat insulation. property: the mineral mortar for plastering is fabricated on the basis of carefully selected filling agent, öåìåíòíî-èçâåñòêîâûõ astringent and special polymer additives, the allotment of that provides good the cohesion with ground, the vapour permeability, the adaptability to manufacture processing, the increasing the efficiency of expenditure, high soil moisture retention capacity. surface preparation: the surface should be dry, dust-free and dirt , butters and other pollutions of organically derived. preparing of mortar for plastering: the mortar for plastering ïðèãîòàâëèâàåòñÿ way of careful mixing with water by hand or mechanically, in ratio of 0, 21-0, 25 waters l by 1 kg dry mixture to receipt required consistency. In operation should be used all content sack. fulfilment of high-quality plaster: the mortar for plastering are deposited on the basis after drying preparatory layer with the help of glabrous metal grater. the surface it levels off to grain depth, and then çàòèðàåòñÿ glabrous plastic grater to needed invoice. Time between coating the plasters and the rubbings depends on absorbing capacity of ground and consistency. One should experimentally to establish maximal the surface, which it is possible îøòóêàòóðèòü in one processing cycle (the coating and the rubbing). expenditure: the expenditure of dry material amount to about 3 kg by 1 ì2 in case of depth deposited layer 2 MM. technical data: mixture proportion: by 1 kg - 0, 21-0, 25 waters l; by 1 sack (25 kg) - 5, 25-6, 25 waters l; application temperature - from +5 degree. With; fitness time of solution - 2-3 part. the product was admitted to use the solar power station,. Moscow.

Die Bedingung der Lieferung:

Preis: der Vertragspreis für kg